Hydraulic System Work Sheet

To better help us apply the correct components for your application, please
have the following information available if possible:

1. Make and model of transmission.: _____________________

2. Type of connection between P.T.O. and driven equipment (check one):
______ Driveshaft
______ Direct mount pump flange
______ Pulleys and belts (requires eng. approval) 

3. Mounting location (check all suitable locations):
______ Left
______ Right
______ Bottom
______ Top   

4. PTO Shift Type:
______ Air Shift
______ Cable Shift
______ Lever Shift (customer supplied linkage)

5. Duty cycle (check one):
______ Intermittent (less than 5 minutes engaged every 15 minutes)
______ Continuous 

6. Type of Hydraulic System: 

Trailer System
              _____  Dump Trailer.   Single acting cylinder _____, or double acting cylinder (s) _____.
              _____  Lowboy, Gooseneck, Walking Floor.   Flow Req'd _______gpm.  Pressure Req'd _______psi.
              _____  Flowboy.   Flow Req'd _______gpm.  Pressure Req'd ________psi.
              _____  Multiple Use (Dual Use, dual pressures required, such as switching between dump and lowboy operations)

On-Truck System
              _____ Dump Truck:
                                      _____ Capacity (yards)

                                      _____ Single Acting Cylinder (example: end dump)
                                      _____ Double Act Cylinder  (example: side dump)

              _____ Wrecker  -- Requirements, functions, etc _________________________________
              _____ Winch  -- Requirements: ______________________________
              _____ Other  -   Requirements: ______________________________
 

6. Hydraulic Valve Control (control valve):
     – Not applicable for Lowboy, Walk Floor systems that have controls on trailer- 
              _____ Air Shift
              _____ Manual (cable, lever, etc)